Deliverables
All of the testing indicated the design and construction of the Beer Brewing Rack System was a success in each requirement. The rack not only passed all requirements, but during testing of brewing, there were no unforeseen issues with the rack. The successful brewing tests indicate this is a useable system. The following is a list of the design requirements and the tested results:
-
Total weight is 72lbs (less than 150 for passing).
-
The rack is approximately 24” x 24” x 60” (less than 30” x 30” x 72” for passing).
-
The tree flexed 1° maximum (less than 2° for passing).
-
Each rack is adjustable for height in 2” increments (as required).
-
Each rack held 200 lbs without yielding; maximum strain was .05% (at least 200lbs required for passing; .2% maximum for A500 steel).
-
Each rack can be mounted to any of the four sides of the tree (as required).
-
Each rack is 11.5” diameter (greater than 8” for passing, still held brew kettles).
-
The 1.2 Safety Factor was included in weights (as required).
Results
